Installation Sheet

INSTALLATION INSTRUCTIONS

For Model 2748-01

READ AND SAVE THESE INSTRUCTIONS

These instructions are provided for your safety. It is essential to read them carefully and completely before installing the

light fixture. We strongly suggest that all direct-wired fixtures be installed by a qualified, licensed electrician.

NCTEUR

PREPARING FOR INSTALLATIONS

Remove all contents from the carton. See the important notes above. Shut off

the power at the circuit breaker and completely remove the old fixture from the

ceiling, including the old mounting strap.

The mounting plate(B) contains several pairs of threaded holes. Find holes that

match the spacing of the holes on the junction box and your fixture’s canopy(F).

Two mounting screws(A) should be attached to the mounting plate(B). You

may need to tighten the nuts that hold these screws in place. Pull the house

wires through the center of the mounting plate(B). Place the mounting plate(B)

over the junction box to align with the holes on the fixture’s canopy(F). Secure

the mounting plate(B) to the junction box by securely tightening the mounting

screws(D) .

ASSEMBLING THE FIXTURE

Screwa short rod(J) to connect with the fixture(K).Screw amiddle rod（I）to

connect with theshort rod(J).Screw a long rod(H)to connect with themiddle

rod(I), andscrew the canopy(F) to connect withthe long rod(H).

CONNECTING THE WIRES

Attach the fixture’s wire to the power supply wires at the junction box. Connect

the black wire to the black wire(or smooth), the white wire to the white(or

ribbed),the ground wire to the ground wire(green or copper). Twist the end

of the wire pairs together, andtwist on a wire connector. Make sure all twists are

in the same direction. If there is no ground wire(green or copper) from the

junction box, locate the ground screw(E) on the mounting plate(B) and wrap

the fixture’s ground wire around the green ground screw(E). Use a screwdriver

to secure the ground screw(E) onto the mounting bracket. Tuck all wires neatly

into the junction box.

FINISHING THE INSTALLATIONS

Placethe canopy(F) to the ceiling and secure the canopy nuts(G) to the

mounting plate (B) in place.Secure the glass(L) andthe metal washer (M)onto

the socket by screwing socket ring(N) until it is tightened. Adjust the glass to

level. Install a light bulb(not included) in accordance with the fixture’s

specifications. Do not exceed the recommended maximum wattage.

Your installation is now complete. Turn on the power and test the fixture.

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

BEFORE INSTALLATION

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PAGE 1
INSTALLATION INSTRUCTIONS For Model 2748-01 READ AND SAVE THESE INSTRUCTIONS These instructions are provided for your safety. It is essential to read them carefully and completely before installing the light fixture. We strongly suggest that all direct-wired fixtures be installed by a qualified, licensed electrician. WAR NI NG ! S H UT PO W ER O F NCTEUR F AT F U S E O R CI RC UIT B R E AK E R BE FO R E I N STAL L AT I O N AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.