Installation Sheet

Page 2 of 2
5. Use the wire connectors (supplied) to connect the wires (see diagram above).Connect the house ground wire to
the fixture ground wire. Connect the house white wire to the fixture supply wire (ribbed sided). Connect the
house black (or red) wire to the fixture supply wire (smooth side). Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires into the outlet box.
6. Place the canopy (F) up to the ceiling junction box, allowing the pre-assembled screws on mounting bracket (B)
to pass through the canopy (F) and secure with locking ball nuts (G).
7. Install the bulb (not included).
Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
8. Position the Glass Shade (O) to the Fixture (M) in slanted direction. Make sure the rim of opening of the Glass
Shade (O) is seated and engaged with the recessed surface of the Support Bar.
Below the Metal Cap (L) onto the Fixture (M) and secure the Glass Shade (O) by turning the Knurled Nut (K),
clockwise by hand until tight.
9. Your installation is now completed. Restore electricity to test for connectivity. If there are any issues turn power
off at the circuit breaker and double check to make sure the wires are connected properly. Retain this sheet for
future reference.
CLEANING AND MAINTENANCE
1. Wipe clean using soft, dry cloth or static duster.
2. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage the finish.