Operational Manual

22
the trigger, rod under the pressure of rod spring slides in
pusher lower side and lifts up, sets in front of pusher,
when trigger sets in forward position.
1.5 Marking
At the device slide should be applied the following
marking: trademark of the manufacturer; shot title of the
device - Fort-9R, caliber - 9 mm P.A.; words "Made in
Ukraine"; national mark of comformity.
Serial number is on the device frame and slide.
1.8 Packing
The device in completeness according to section
1.3 of this manual is packed in package suitable for
storage.
2 DEVICE OPERATION
2.1 Safety measures
Before carrying out any actions with the device,
it is necessary to learn all rules and methods of firing,
operation principles and maintenance of the device, which
are given in this manual.
During loading or discharging of the device, point
the barrel in safe direction.
Discharge the device after firing, and before
disassembly, cleaning and greasing.
Keep your finger away from the trigger until device
is aimed to the target.
Keep the device and cartridges separately in
places which are reliably closed and unattainable for
others.
The device must be always clean and greased.
7
Aim and press the trigger. After the first shot
case ejection through the ejection slot and next cartridge
feeding to the chamber will be done automatically. To
continue shooting you must release and press the trigger
till using all magazine rounds.
2.3.3 Slide is in forward position after shot.
2.4 Unloading of the device
Point the device barrel in safe direction, turn out
the magazine by pressing the magazine release. Pull the
slide in the rearmost position, if cartridge was in the
chamber - eject it through ejection slo t.
Check the cartridge chamber, make sure that it
is empty, release the slide.
Pick up the drawn cartridge, pull out the unused
cartridges from the magazine, and insert the magazine
into the device handle hole.
2.5 Handling operations in case of firing delay
The list of delays and handling operations are
below:
1) if you press the trigger but the shot failed -
reload the device and continue shooting;
2) slide did not reach the extreme front position
after the automatic reloading - move with your hand the
slide forward and continue firing, if it is impossible, follow
the actions according to item 3 of section 2.5;
3) during automatic reloading when the cartridge
is jammed between the face of slide and breech end of
the barrel - point the barrel in a safe direction, press the
magazine locking button and disconnect magazine, pull
20
9