Operational Manual

1 PRODUCT DESCRIPTION
1.1 Function
The device is intended for self-defense of
persons, which have the right its of use, carry and
keeping, according with the law.
1.2 Technical data
1.2.1 Device technical parameters:
Caliber .................................................. 9 mm P.A.
Minimum distance while shooting
for live target, m ............................................... 3,5
Maximum firing range,m .................................. 10
Trigger pull, (N), not more than ...................... 55
Magazine capacity, cartridges ......................... 7
Overall sizes, mm, not more:
length ................................................................ 145
height ................................................................ 114
width .................................................................. 25
Weight with an empty magazine,
kg, not more ................................................... 0,52
1.2.2 For shooting from the device you should
use cartridges, equipped with the elastic bullet of non-
lethal action, which are certificated.
1.2.3 The device design eliminates the possibility
of shooting with ball-cartridges intended for firearms and
provides impossibility of replacement of the basic parts
with similar parts from military or sport guns.
ATTENTION!
UNAUTHORIZED REPLACEM ENT OF
DETAILS AND CHANGE OF THEIR CONSTRUCTION
IS FORBIDDEN AND PUNISHED IN COMPLIANCE
WITH LAW.
4
and in the extreme front position closes the cartridge
chamber with chamber inside by breeching face. The
extractor hook runs into circular part of the cartridge-
case.
A shot is carried out by pressing the trigger.
Herewith, the rod which is connected with the trigger,
moves back in the internal cavity of the frame and presses
on the cross shoulders of the pusher, connected with
hammer, and forces returning it around an axis. Herewith,
firing pin guide, which bumps hammer plunger, squeezes
the firing spring.
Simultaneous, pusher with hammer turns around
hammer axis so, that cross shoulders of the pusher allow
to slide down to rod back part. The pusher disconnects
with rod, and released hammer strikes firing pin under
the action of firing spring, the acute end of firing pin
broke percussing cup of cartridge which is in cartridge
chambe and shot is happen.
The pressure of powder gases pushes the bullet
forward on the barrel and forces slide to move back. The
moving back slide presses the recoil spring; spent case
engaged by the extractor hook, ejectes out from the
cartridge chamber through the slide slot. When moving
back slide gets of rearmost position recoil spring starts to
expand and pushes slide forward. Moving forward slide
ejects out of magazine the cartridge into cartridge
chamber, slide is set in forward position and locks
cartridge in the cartridge chamber. While slide is moving
back and forth, hammer moves at the same time as it.
To continue shooting you must release and press
the trigger till using all magazine rounds.While releasing
Parts list of "Fort-9R" for figures 1, 2, 3
Magazine safety
Recoil spring guide
Slide lock
Handle plate
Grip screws
Recoil spring
Firing spring stop
Extractor pin
1 Barrel
26
2 Hammer
27
3 Interrupter
28
4 Interrupter pin
29
5 Trigger
30
6 Rod
31
7 Rod spring
32
8 Trigger bar pin
33
9 Frame
10 Ejector
11 Firing spring lever
12 Magazine locking
13 Magazine locking spring
14 Hammer pin
15 Trigger axis
16 Barrel pins
17 Slide
18 Firing pin
19 Firing pin spring
20 Firing pin pin
21 Extractor
22 Magazine body
23 Magazine follower
24 Magazine bottom
25 Magazine plate
6