Science Industrial association E T FOKT W of the MIA of Ukraine -- - / 3 A----------1 Device for shooting cartridges equiped with elastic bullets of non-lethal action "Fort-9R" caliber 9 mm P.A. SIA «Fort» of the MIA of Ukraine 600-richchya Street 27 Vinnitsa, 21027, Ukraine tel. (0432) 46-73-26 fax (0432) 46-80-16 siafort@ ukr.net O p e r a tio n a l Manual Science Industrial association Device for shooting cartridges equiped with elastic bullets of non-lethal action ”Fort-9R" caliber 9 mm P.A.
This operation m anual is intended fo r the learning o f the principle o f action and rules of o p e ra tio n s o f device fo r sh oo tin g c a rtrid g e s equiped with elastic bullets o f non-lethal action "Fort-9R" caliber 9 mm P.A. (hereinafter - device) and co n ta in s in fo rm a tio n a b o u t the d e sig n , o p e ra tin g p ro ce d u re s, s a fe ty re q u ire m e n ts , d is a s s e m b ly and a s s e m b ly ru le s, cle a n in g , greasing, storage and guarantee statement.
1 PRODUCT DESCRIPTION 1.1 Function The device is intended fo r self-defense of persons, which have the right its of use, carry and keeping, according with the law. 1.2 Technical data 1.2.1 Device technical parameters: Caliber.................................................. 9 mm P.A. Minimum distance while shooting for live target, m ...............................................3,5 Maximum firing range,m ..................................10 Trigger pull, (N), not more than......................
the trigger, rod under the pressure of rod spring slides in pusher lower side and lifts up, sets in front of pusher, when trigger sets in forward position. 1.5 Marking At the device slide should be applied the following marking: trademark of the manufacturer; shot title of the device - Fort-9R, caliber - 9 mm P.A.; words "Made in Ukraine"; national mark of comformity. Serial number is on the device frame and slide. 1.8 Packing The device in completeness according to section 1.
Cleaning and greasing of the device should be done in accordance with instructions, which are given in section 3 of this manual. Never load and do not keep the device loaded, if you aren’t going to fire. 2.2 Preparation for firing 2.2.1 Checking of the device before firing. Point the barrel of the device in safe direction, examine the external part of the device, press by thumb the magazine release, which is located on the left side of the device, and w ith ano the r hand s u pp ort falling magazine.
5 STORAGE OF THE DEVICE For a long-term storage o f the device it is necessary to carry out its preservation. Procedure for the carry out preservation is done in the section 3.10 of this manual. After canning you should wrap up the device with p a p e r. Preserved and packed device must be stored in the closed storehouses, where temperature and humidity fluctuation are less than in open air. Maximum storage term of the canned device is not more one year from the canning.
By wiper through the slot of handle retract right (curved) end of magazine locking button spring left/up so, that curved end run out of button deepening, holding pressed spring, pull out it direct end from button hole, push out the spring of fram e groove, then pull out magazine locking button from fram e hole. Push out the trigger axis by drift pin and pull down the trigger so, that its end will enter into hole of trigger bow, herewith connectivity node of trigger with rod will be out of frame.
