User Guide

20
Register animals to allow feeding
Enter
This is automatically displayed after switching on the machine
QUICK START GUIDE
Automatic calf feeder powder- 1.1 Installation checklist
Fill the boiler
15
Fault message boiler is automatically displayed
press
Reinstall everything
16
device data
conrm everything
new installation
Enter
boiler is lled now
ESC
= back
ENTER
= conrm
Auto
i
C
Esc
Enter
1
2
3
6
5
4
7
8
9
0
Enter basic settings (date & time)
14
First settings at the Handheld
This checklist refers to the basic equipment of the calf feeder. Not all available functions of the automatic feeder or the extensions can be shown.
For detailed information and valid warnings as well as safety instructions, please refer to the instructions manual. (Status 21/07)
Setup conguration
15
Check / change Setup settings
Setup
language:
time/date
machine
equipment
identication
ID-chip
calibration scale
stations
terminal
communication
SD card
service
Adjust the calibration scale if available then exit
Setup
b)
c)
[ English]
Attention: detergent quan-
tity is set to 0ml by default
Read in ID-chip
read?ID-chip
a)
Keep pressed
Turn on the feeder and hold button
until the setup menu is displayed.
Turn of the feeder
[ setup menu ]
Calibration
16
Calibrate all existing components at least 3 times
during initial commissioning.
calibration
components
Water, MP, additives
TIP: check QuickStartGuide 1.3 & 1.4 Calibration
TIP: check QuickStartGuide 1.6 & 1.7 Cleaning
TIP: check QuickStartGuide 1.2 feeding plan
Cleaning before commissioning
17
Fill up detergent & clean
Check cleaning settings
cleaning
circuit cleaning
start?
cleaning
settings
Circuit cleaning
Reading in transmitters to store them in the system
Set feeding plans, portion settings and
operating mode
19
18
or
TIP: check QuickStartGuide 1.8 animal management
animal management
transmitter
new
Hold a transmitter next to the an-
tenna in the raceway.
Create new no. X for animal X?
Enter
automatically
automatic
Enter
animal management
register
Besides a manual registration, it is possible to
register calves automatically to the calf feeder.
TIP: check QuickStartGuide 1.8 animal management