User manual

Check the position of the flap
1. Pull out the detergent dispenser until it
stops.
2. Press the lever down to remove the
dispenser.
1
2
3.
To use powder detergent, turn the flap
up.
A
4. To use liquid detergent, turn the flap
down.
B
With the flap in the position
DOWN:
• Do not use gelatinous or
thick liquid detergents.
• Do not put more liquid
detergent than the limit
showed in the flap.
• Do not set the prewash
phase.
• Do not set the delay start
function.
5. Measure out the detergent and the
fabric conditioner.
6.
Carefully close the detergent dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.
Setting a programme
1.
Turn the programme knob. The related
programme indicator comes on.
The indicator of button Start/Pause -
Départ/Pause flashes with red colour.
The display shows the default temperature,
the spin speed and the empty indicator
bars of the available functions.
2. To change the temperature and/or the
spin speed, press the related buttons.
3. Set the available functions.
Starting a programme without
the delay start
Press button Start/Pause - Départ/Pause to
start the programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase is
operation starts to flash.
The programme starts, the door is locked.
The display show the indicator
.
The drain pump can operate for
a short time when the appliance
fills water.
Starting a programme with the
delay start
1. Press button Zeitvorwahl - Départ
Différé again and again until the display
18