User manual

• The programme progress display shows
the washing phases of the selected pro-
gramme.
• During a washing cycle, a black line blinks
under the washing phase symbol of the
running programme. At the end of each
washing phase, the line under the corre-
sponding symbol becomes fixed.
If the OVERDOSAGE symbol lights up at
the end of the programme, it indicates
that too much detergent has been used.
9.4 - Options: PREWASH
, STAIN ,
SENSITIVE
, EXTRA RINSE
9.5 - DOOR - symbol (Door locked)
• This symbol indicates if the door can be
opened:
– the symbol is on: the door cannot be
opened. The appliance is performing a
washing programme.
– the symbol is off: the door can be
opened. The washing programme is fin-
ished.
9.6 - TIME SAVING
- option symbol
9.7 - The display shows the following infor-
mation:
• Duration of the selected programme
– After selecting a programme, the dura-
tion is displayed in hours and minutes
(for example
. The duration is cal-
culated automatically on the basis of the
maximum recommended load for each
type of fabric.
– After the programme has started, the
time remaining is updated every minute.
• Delay start
– The selected delay (20 hours max) set
by means of the relevant button appears
on the display for about 3 seconds (for
example
), then the duration of the
previously selected programme is dis-
played.
– The DELAY START symbol will appear
on the display.
– The delay time value decreases by one
unit every hour and then, when remains
1 hour, the time decreases every mi-
nute.
• Incorrect option selection
– If an option which is not compatible with
the set wash programme is selected,
the message Err is displayed for about
2 seconds and the yellow light of button
7 starts blinking.
•Alarm codes
– In the event of operating problems,
some alarm codes can be displayed, for
example
(see chapter «What to do
if...»).
• End of the programme
– When the programme has finished a
blinking zero
is displayed, the DOOR
symbol disappears and the door can be
opened.
9.8 - DELAY START
- symbol
9.9 - CHILD SAFETY LOCK
- symbol
First use
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Before the first wash, run a cotton cy-
cle at the highest temperature without
any laundry in the machine, to remove
any manufacturing residue from the
drum and tub. Pour 1/2 a measure of
detergent into the main wash com-
partment and start the machine.
Personalization
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simultane-
ously for about 6 seconds, the acoustic sig-
nal is deactivated (except for the events of
operating problems). By pressing these two
buttons again, the acoustic signal is reacti-
vated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
6