User manual

Please ensure that when the appliance is in-
stalled, it is easily accessible for the engineer
in the event of a breakdown.
Carefully level by screwing the adjustable feet
in or out. Never place cardboard, wood or
similar materials under the machine to com-
pensate for any unevenness in the floor.
Water inlet
An inlet hose is supplied and can be found
inside the machine drum.
This appliance must be connected to a
cold water supply.
Do not use the hose from your previous
machine to connect to the water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine.
Important! Do not place the inlet hose
downwards. Angle the hose to the left or
right depending on the position of your
water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations require-
ments. Check the minimum water pressure
required for safe operation of the appliance
in the chapter "Technical Data".
Water-stop device
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window «A» . Should this occur, turn the
water tap off and refer to your Service Centre
to replace the hose.
25