User manual

4. Slide out the relevant plastic spacers.
5. Open the porthole, take out the inlet hose
from the drum and remove the polystyr-
ene block fitted on the door seal.
6. Fill the smaller upper hole and the two
large ones with the corresponding plastic
plug caps supplied in the bag containing
the instruction booklet.
7. Connect the water inlet hose as descri-
bed under the paragraph «Water inlet».
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the ma-
chine is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the
floor by putting pieces of wood, cardboard
or similar materials under the machine.
If it is impossible to avoid positioning the ma-
chine next to a gas cooker or coalburning
stove, an insulating panel covered with alu-
minium foil on the side facing the cooker or
stove, must be inserted between the two ap-
pliances.
The machine must not be installed in rooms
where the temperature can drop below 0°C.
The water inlet hose and the drain hose must
not be kinked.
24