User manual Washing Machine WE 7451 - WE 7651
Contents Safety information Product description Control panel First use Personalization Daily use Washing programmes 2 4 5 6 6 7 11 Helpful hints and tips Care and cleaning What to do if… Technical data Consumption values Installation Environment concerns 15 16 19 22 23 23 26 Subject to change without notice Safety information Important! Read carefully & keep for future reference.
• After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from hoses and their connections after the installation.
Product description Product description Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. The NEW JET system allows total use of detergent and reduces water consumption so saving energy. 2 1 3 4 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle Detergent dispenser drawer Compartment for detergent used for prewash. The prewash detergent is added at the beginning of the wash programme.
Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and the display. These are presented by relevant numbers on the following pages. 9 1 2 3 1 Programme selector dial 2 TEMPERATURE button ( TEMP. ) 3 SPIN reduction button ( U/MIN.
• The programme progress display shows the washing phases of the selected programme. • During a washing cycle, a black line blinks under the washing phase symbol of the running programme. At the end of each washing phase, the line under the corresponding symbol becomes fixed. If the OVERDOSAGE symbol lights up at the end of the programme, it indicates that too much detergent has been used. , STAIN , 9.4 - Options: PREWASH SENSITIVE , EXTRA RINSE 9.
dren might be injured by or cause damage to the appliance. This function remains able also when the washing machine is not working. To enable (or disable) this option press simultaneously for about 6 seconds buttons 4 and 5 until the Child Lock symbol appears on (or disappears from) the display. There are two different ways to set this option: • Before pressing button 7 : it will be impossible to start the machine.
Select the required programme by means of programme selector dial (1) You can choose the right programme for any type of laundry following the descriptions on the washing programme tables (see «Washing Programmes»). Turn the programme selector dial to the required programme. The programme selector determines the type of washing cycle (e.g. water level, drum movement, number of rinses) and the washing temperature according to the type of laundry.
has been set. Press the same button to deactivate the option. After selecting the options, wait about few seconds until the display gets back to the default status. The selected options appear on the display. If you wish to activate this option permanently press simultaneously buttons 2 and 3 for some seconds: the relevant symbol appears on the display. If you wish to cancel it press the same buttons until the symbol disappears.
and then by 1 hour up to a maximum of 20 hours by means of this button. The selected delay time value will appear on the display for about 3 seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 7 . You can modify or cancel the delay time at any moment, before you press the button 7 . The door will be locked throughout the delay time.
open to prevent the formation of mildew and unpleasant smells. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status.
Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry Options PFLEGELEICHT -SYNTHETIQUES SYNTHETICS 60°- Cold Main wash - Rinses - Short spin Max. load 3,5 kg - Reduced load 2 kg Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses. SPIN REDUCTION NIGHT CYCLE RINSE HOLD PREWASH1) STAIN2) SENSITIVE EXTRA RINSE TIME SAVING 3) LEICHTBÜGELN PLUS - REPASSAGE FACILE PLUS EASY IRON PLUS 60° - Cold Main wash - Rinses - Short spin Max.
Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry SCHLEUDERN - ESSORAGE SPIN Drain and long spin Max. load 7 kg Separate spin for hand washed cotton garments and after programmes with the option selected that ends with water left in the tub. The selector dial must be Options SPIN REDUCTION . You can choose the spin speed by turned to pressing the relevant button to adapt it to the fabrics to be spun.
Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry Options SPORT INTENSIV - SPORT SPORT INTENSIVE 40° - Cold Prewash - Main wash - Rinses - Short spin Max. load 3 kg Special programme is suitable for washing heavily soiled sport items. The machine will add automatically a prewash phase before the main wash to eliminate mud stains. We recommend you NOT to put the decompartment of the detergent tergent into the drawer.
Programme Maximum and Minimum Temperature Cycle Description Maximum Fabrics Load Type of Laundry Options Detergent Compartment / AUS ARRET = OFF For cancelling the programme which is running or to switch the machine off . 1) If using liquid detergents, a programme without prewash must be selected. 2) Stain option can be selected only at the temperature of 40°C or higher. 3) If you select the Super Quick option by pressing button 6 , we recommend that you reduce the maximum load as indicated.
The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.), the colour, washing temperature and degree of soiling. All commonly available washing machine detergents may be used in this appliance: • powder detergents for all types of fabric • powder detergents for delicate fabrics (60°C max) and woollens • liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only.
3. Clean all parts with water. 4. Put the conditioner insert in as far as it will go, so that it is firmly in place. 5. Clean all parts of the washing machine, especially the nozzles in the top of the washing-in chamber, with a brush. 6. Insert the detergent dispenser drawer in the guide rails and push it in.
water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filters 6. When no more water comes out, unscrew the pump and remove it. Always keep a rag nearby to dry up spillage of water when removing the pump.
7. Screw the hose back to the machine and make sure the connection is tight. 8. Turn on the water tap. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: 1. close the water tap and unscrew the water inlet hose from the tap; 2. place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out; 3.
Problem Possible cause/Solution The washing machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and the button 7 has not been depressed. • Please turn the selector dial and press the button 7 again.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain hose is damaged. • Change it with a new one.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after some minutes, the laundry is still not evenly distributed in the drum, the machine will not spin. • Redistribute the laundry.
Spin Speed Maximum 1400 rpm (WE 7451) 1600 rpm (WE 7651) Consumption values Programme Energy consumption (KWh) Water consumption (litres) White Cottons 95° 2.1 62 Cottons 60° 1.35 58 Cotton Energy Saving Programme 60° 1) 1.05 45 Cottons 40° 0.75 58 Synthetics 40° 0.55 51 Delicates 40° 0.55 63 Wool/ Handwash 30° 0.25 58 Programme duration (Minutes) For the duration of the programmes, please refer to the display on the control panel.
plug caps supplied in the bag containing the instruction booklet. 4. Slide out the relevant plastic spacers. 7. Connect the water inlet hose as described under the paragraph «Water inlet». 5. Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted on the door seal. 6. Fill the smaller upper hole and the two large ones with the corresponding plastic Positioning and levelling Install the machine on a flat hard floor.
Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Water inlet An inlet hose is supplied and can be found inside the machine drum. This appliance must be connected to a cold water supply.
Water drainage The end of the drain hose can be positioned in three ways: 1. Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. 2. In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. 3.
product, please contact your local council, your household waste disposal service or the shop where you purchased the product. Packaging materials are The materials marked with the symbol recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers.
132947290 - 00 - 052010
