User manual

38
Electrical connection
Details about the voltage, type of supply and the fus-
es required are to be found on the rating plate. The
rating plate is next to the doorway.
Connecting to the water supply
Important!
• This appliance must not be connected to the hot
water system.
• When connecting it, use only new hose kits.
• Only connect the appliance to the drinking water
supply. Rain water or water for industrial use may
only be used if it fulfils the requirements of
DIN1986 and DIN1988.
• Do not kink or crush the water inlet hose or drain
hose.
Permitted water pressure
The water pressure must be at least 1bar (=10N/
cm
2
=0.1MPa) and may be a maximum of 10bar
(=100N/cm
2
=1MPa).
– If more than 10bar: Connect a pressure reduction
valve.
– If less than 1bar: Disconnect the appliance end of
the inlet hose from the solenoid inlet valve and re-
move the flow meter. (In addition remove the filter
using pointed pliers and take out the rubber gasket
behind it.) Re-insert the filter.