User manual

27
Water is leaking out from un-
der the washing machine.
The screw connection on the inlet
hose is leaking.
Screw the inlet hose in firmly.
The drainage hose is leaking. Replace drain hose.
The drain pump cover is not closed
properly.
Close the cover properly.
Washing was caught in the door.
Load washing carefully for the next
wash.
Emergency drain hose is leaking.
Close off emergency drain hose prop-
erly.
Softener was not washed in.
w
compartment for condi-
tioners is filled with water.
The conditioner insert is not correctly
set into the additive compartment or
is blocked.
Clean the detergent dispenser drawer,
insert the conditioner insert firmly.
Washing is heavily creased.
There may have been too much
washing in the machine.
Observe maximum loads.
The door cannot be opened
when the appliance is
switched on. The
N
symbol
appears in the display.
The door is locked for safety reasons. Wait until the O symbol appears.
The display goes out while a
wash cycle is running.
Power cut.
For safety reasons, the door will re-
main locked for approx. 4 minutes.
The programme will continue when
the power cut is over.
To remove washing:
If water can be seen in the appliance,
before opening the door, first perform
an emergency drain.
The background illumination
of the display has gone out
even though the appliance is
switched on.
The washing machine is in stand-by
mode.
Press any key.
Water is not entering the appli-
ance. ATTENTION ERROR
CODE (C1)/PLEASE OPEN
THE WATER TAP appears in
the display.
Tap turned off. Turn on the tap.
The filter in the threaded inlet hose fit-
ting is blocked.
Turn off the tap. Unscrew the hose,
take out the filter and clean it.
Water tap is furred with lime scale or
is faulty.
Check the tap and have it repaired, if
necessary.
The washing has not been
spun thoroughly and water re-
mains visible in the drum.
ATTENTION ERROR CODE
(C2)/PLEASE CHECK THE
WATER DRAINAGE appears in
the display.
Drain hose is kinked. Remove kink.
Maximum pumping height of 1m ex-
ceeded.
Please contact your Local Service
Force.
The drain pump is blocked.
Clean the drain pump. Remove for-
eign bodies from the pump housing.
For siphon connections: The siphon is
blocked.
Clean the siphon.
Problem Possible cause Remedy