User manual

20
Washing cycle complete/
Removing the washing
At the end of the programme PLEASE TAKE OUT
THE CLOTHES appears in the display. As soon as
the O
§ symbol appears, the door can be opened.
1. Open the door using the handle.
2. Remove the washing.
3. Switch off the appliance.
If Rinse Hold has been selected:
1. Press the START key.
The washing will be spun.
(Reduce spin speed if required.)
If short spinning or draining is required:
1. Switch the appliance off and then on again.
2. Use the control knob to highlight either
– SHORT SPIN or
– DRAIN.
3. Press the START key.
The washing is gently spun or the water is drained.
3 If OVERDOSING is shown in the display at the
end of a wash cycle, too much detergent was
used in the completed wash programme.
Please take note of the dosage instructions
provided by the detergent manufacturer and
the amount of washing loaded the next time
you wash.
DELICATES 30°C
RINSE HOLD 11:25-11:29
N§
START
RINSE HOLD
######################
RINSE H.
SHORT SPIN
800 RPM 11:28-12:34
Nú
START
VISCOSE
SHORT SPIN(
SPIN
800
STARCH
OPTIONS DRAIN