User manual

19
Machine settings
SSeettttiinngg IImmpplleemmeennttaattiioonn
BBUUZZZZEERR ppeerrmmaanneenntt ooffff
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and SPIN SPEED
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use
BUZZER button to activate or deactivate sound but
machine does not memorize your selection.
WWaatteerr hhaarrddnneessss
Water contains, a variable quantity of
limestone and mineral salts of which
quantities var
y according to geo-
graphical locations thus varying its
conductivity values.
Relevant variations of the conductivi-
ty of the water compared to those
prefixed by the factory could slightly
influence the residual humidity of the
laundry at the end of the cycle. Your
dryer allows you to regulate the sen-
sitivity of the drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and TIME buttons
and hold down for approx. 5 seconds. The current set-
ting is on the display:
– low conductivity <300 micro S/cm
– medium conductivity 300-600 micro S/cm
– high conductivity >600 micro S/cm
3.
Press the START PAUSE button sequentially until you
set desired level.
4. To memorize setting press simultaneously the DRYNESS
and TIME buttons or turn knob to OFF position
EEmmppttyyiinngg wwaatteerr ttaannkk -- wwaarrnniinngg mmeessssaaggee
ppeerrmmaanneenntt ooffff
When using an external drain for
the condensed water
.
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED and TIME buttons
and hold down for approx. 5 seconds.
The current setting is on the display:
– warning icon and - warning message is off
– warning icon and - warning message is
switched on
By default the warning message is switched on and
displayed always at the end of the drying cycle or dur-
ing the cycle if the water container is full.