User manual

17
Machine settings
SSeettttiinngg IImmpplleemmeennttaattiioonn
BBUUZZZZEERR SSIIGGNNAALL ppeerrmmaanneenntt ooffff
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE SCHON and
BUZZER SIGNAL buttons and hold down for approx. 5
seconds the result can be following:
- diode above BUZZER SIGNAL button starts lighting -
BUZZER SIGNAL permanently on.
- lighting diode comes off - BUZZER SIGNAL permanentl
off.
3. The buzzer is by default always off. You can use
BUZZER SIGNAL button to activate or deactivate sound
but machine does not memorize your selection.
WWaatteerr hhaarrddnneessss
Water contains, a variable quantity of
limestone and mineral salts of which
quantities var
y according to geo-
graphical locations thus varying its
conductivity values.
Relevant variations of the conductivi-
ty of the water compared to those
prefixed by the factory could slightly
influence the residual humidity of the
laundry at the end of the cycle. Your
dryer allows you to regulate the sen-
sitivity of the drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE SCHON and
START PAUSE START PAUZE buttons and hold down
for approx. 5 seconds. The current setting is shown by
lighting status diode:
- TANK BEHÄLTER diode - low conductivity >600 micro
S/cm
- FILTER SIEB diode - medium conductivity 300-600
micro S/cm
- CONDENSER WÄRMETAUSCHER diode - high conduc-
tivity <300 micro S/cm
3. Press the START PAUSE START PAUZE button sequen-
tially until you set desired level.
4. To memorize setting press simultaneously the DELICATE
SCHON and START PAUSE START PAUZE buttons or
turn knob to OFF AUS position
EEmmppttyyiinngg wwaatteerr ttaannkk -- wwaarrnniinngg mmeessssaaggee
ppeerrmmaanneenntt ooffff
When using an external drain for
the condensed water
.
1. Turn the programme selector to any programme.
2. Press simultaneously the BUZZER SIGNAL and DELAY
ZEITVORWAHL buttons and hold down for approx. 5
seconds. The current setting is shown by lighting TANK
BEHÄLTER diode:
- TANK BEHÄLTER diode flashes - warning is permanently
off
- TANK BEHÄLTER diode flashes and becomes steady -
led warning is activated
By default the warning message is switched on and
displayed always at the end of the drying cycle or dur-
ing the cycle if the water container is full.