User manual

15
What to do if ...
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
b
b
y
y
y
y
o
o
u
u
r
r
s
s
e
e
l
l
f
f
If, during operation, the dryer shows an error
(one or mor
e leds flashing on the control
panel), check first of all whether you can
remedy the problem yourself by means of
the table below. If you cannot solve the
problem: Switch the machine off and on
again. Reset programme. Press the START
PAUSE START PAUZE button. If the error is
still shown, please contact our after-sales
service and inform them which leds are
flashing.
PPrroobblleemm PPoossssiibbllee ccaauussee RReemmeeddyy
Dryer does not work.
Mains plug is not plugged in or
fuse is not working correctly.
Plug in at mains socket. Check
fuse in fuse box (domestic instal-
lation).
Loading door is open. Close loading door.
Have you pressed the START
PAUSE START PAUZE button?
Press the START PAUSE START
PAUZE button again.
Dryer does not work.
Wrong programme selected.
Select a different programme the
next time you dry (see
“Programme chart” chapter).
Lint filters clogged. Clean lint filters.
Fluff filter clogged. Clean fluff filter.
Heat exchanger clogged with lint. Clean heat exchanger.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots in base area cov-
ered up.
Uncover ventilation slots in base
area.`
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Re-programme standard setting
for degree of drying (see
‘Programming options’ chapter).
Loading door does not close.
Fine strainer not in place and/or
mesh filter not locked in place.
Install fine strainer and/or snap
large mesh filter into place.
When a button is pressed, led
above START PAUSE START
PAUZE button is lighting in yellow
temporarily.
Washing protection. After the
start of the programme, the
option can no longer be set.
Turn the programme knob to OFF
AUS. Set the programme again.