User manual

8
Use
The control panel
7654321
1 Programme/Time selector dial
Allows you to select electronically controlled or time
controlled drying.
Turn the dial to the required programme or time.
Electronically controlled drying
(automatic)
The appliance runs these programmes with the help
of probes which detect the degree of dampness of
the laundry.
Simply select the programme according to the type
of laundry and degree of drying required.
2 Long Anticrease - KNITTERSCHUTZ
PLUS/ANTI-FROISSAGEl
If this additional function is selected, the anti-crease
phase at the end of the drying cycle is lengthened
by 60 minutes. The laundry can be removed at any
time during the anti-crease phase.
3 Low temperature button - SCHON
Pressing this button allows drying to be performed
at a lower temperature, for delicate items.
The corresponding pilot light comes on.
This option can also be used for time controlled drying.
4 Buzzer OFF button - SIGNAL
A buzzer sounds
• when selecting the programme
• when depressing the buttons
• when an incorrect option selection is made
• when the programme selector dial is turned to
another position during the programme or when
you depress an option button during the cycle
• at the end of the programme
• when the water reservoir is full
• if the machine is not working correctly
• when the small door at the bottom is open
By depressing button “SIGNAL” the acoustic signal
is switched off.
The corresponding light comes on.
5 Start/pause button - START/PAUSE
Press this button to start the dryer after having s
elected the programme and the options.
The relevant light will stop flashing. If you have
chosen a delayed start, the machine will begin the
countdo wn.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the
programme from the point at which it was
interrupted.
This button must also be depressed after a
power failure and after having re-inserted the
water reservoir, if it has been emptied in the
middle of a programme after lighting up of the
“BEHÄLTER” light.
In both cases the light of the Start/Pause button
flashes to remind you that the start button needs to
be pressed again.
6 Indicator lights
These lights indicate the following functions:
SIEBE light (Clogged filters)
This light illuminates at the end of the programme to
remind you that the filters must be cleaned.
BEHÄLTER light - (Full tank)
125987691_2.qxp 2007-06-20 13:50 Page 8