User manual

43
the wash cycle is much too long : •the water inlet filters are dirty,
•the power or water supply has been cut off,
•the motor overheating detector has been activated,
•the water inlet temperature is lower than usual,
•the foam detection security system has been activated (too much
detergent) and the washing machine has begun draining the foam,
•the out of balance detector has been activated : an extra phase has
been added to distribute washing more evenly in the drum.
The washing machine stops during a
wash cycle :
•the water or electricity supply is defective
•a Rinse hold has been selected,
•the drum shutters are open.
The lid doesn’t open at the end of
the cycle :
•the “immediate opening”
*
light is not lit,
•the temperature inside the drum is too high,
•the lid unlocks 1 - 2 minutes after the end of the cycle*.
The E40 error code appears in the
display
**
and the Start/Pause pus-
hbutton flashes red
***
:
•the lid isn’t closed properly.
The E20 error code appears in the
display** and the Start/Pause pus-
hbutton flashes red*** :
•the drainage filter is obstructed,
•the drain hose is blocked or bent,
•the drain hose is fixed too high (see “Installation” section).
•the drainage pump is blocked,
•the standpipe is blocked.
The E10 error code appears in the
display** and the Start/Pause pus-
hbutton flashes red*** :
•the water inlet tap is closed,
•the water supply has been cut off.
The EF0 error code appears in the
display** and the Start/Pause pus-
hbutton flashes red*** :
•the drainage filter is obstructed,
•the anti-flooding security system has been activated, please proceed
as follows :
- close the water inlet tap,
- empty the appliance for 2 minutes before unplugging,
- call the after-sales service.
The drainage pump runs constantly,
even when the appliance is inactive:
•the anti-flooding security system has been activated, please proceed
as follows :
- close the water inlet tap,
- empty the appliance for 2 minutes before unplugging,
- call the after-sales service.
Softener runs directly into the drum
when filling the dispenser box :
•you have gone past the MAX indicator.
* Depending on model.
**On some models, the audible signals can sound.
*** After solving any problems, press the ‘Start/Pause’ pushbutton to restart the interrupted programme.
Problems Causes