User manual

36
“Delay start” (Startzeitvorwahl)
This option allows you to delay the start of a
wash programme by 30, 60, 90, 2 hours to 20
hours.
The selected time appears on the display for a
few seconds.
You can change or cancel the delayed start time
at any time before you press the “Start/Pause”
pushbutton, by pressing the “Delay start” (Start-
zeitvorwahl) pushbutton again (0’ indicates
immediate start).
If you have already pressed the “Start/Pause”
pushbutton and you want to change or cancel
the delayed start, proceed as follows :
• To cancel the delayed start and start the cycle
immediately, press “Start/Pause” and then
“Delay start” (Startzeitvorwahl). Press “Start/
Pause” to start the cycle.
• To change the timer delay period, you must go
through the “Off” position and reprogram
your cycle.
WARNING !
The lid will be locked during the delayed start
time. If you need to open it, you must first pause
the appliance by pressing the “Start/Pause” pus-
hbutton. After closing the lid again, press the
“Start/Pause” pushbutton.
Start of the programme
Press the “Start/Pause” pus-
hbutton to start the cycle. The
corresponding light will come
on green. The “Door locked”
(Deckel verriegelt) indicator
lights up (door locked).
It is normal for the programme selector to remain
stationary during the cycle.
The remaining time appear on the display.
If a delayed start has been selected, the coun-
tdown appears on the display (hour by hour,
then 90, and minute by minute from 60 min).
Interrupting a programme
Adding washing during the first 10 minutes
When the “Door locked” (Deckel verriegelt) light
is off, you can add washing by proceeding as fol-
lows.
Press the “Start/Pause” pushbutton : the corres-
ponding light will flash green while the appliance
is paused. The lid can only be opened around 2
minutes after the washing machine has come to
a stop. Press the “Start/Pause” pushbutton
again to continue the programme.
Modifying the programme in progress
Before making any changes to the current pro-
gramme, you need to pause the washing
machine by pressing the “Start/Pause” pushbut-
ton. If the modification is not possible, “Err”
flashes in the display and the “Start/Pause” pus-
hbutton flashes red for a few seconds. If you still
decide to change the programme, you must can-
cel the current programme (see below).
Cancelling the programme
If you want to cancel the programme, turn the
programme selector to the “Off” position.
End of the programme
The washing machine stops automatically ; the
“Start/Pause” pushbutton goes out and “0”
flashes on the display. The lid can only be ope-
ned around 2 minutes after the washing machine
has come to a stop. The “Door locked” light is
off.
2h
1.12