User manual

• The indicator continues to flash.
• The display shows the current
setting: = Acoustic signal off.
3. Press to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm the
setting.
How to set the colour of the
TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
The appliance must be in programme
selection mode.
1.
To enter the user mode, press and hold
simultaneously
and until the
indicators , , , , and
start to flash and the display is blank.
2. Press
.
• The indicators , , , and
go off.
• The indicator
continues to flash.
• The display shows a number and the
letter C. Each number refers to a
different colour.
– = TimeBeam deactivated.
3. Press again and again to change the
colour.
• You can see the different colours on
the kitchen floor.
4. Press the on/off button to confirm the
setting.
AirDry
AirDry improves the drying results with less
energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is then
kept ajar.
CAUTION! Do not try to close
the appliance door within 2
minutes after automatic open.
This can cause damage to the
appliance.
CAUTION! In case of presence
of children, the AirDry system
can be deactivated if you want
to keep the door closed in the
end of the cycle.
AirDry is automatically activated with all
programmes excluding Vorspülen
To improve the drying performance refer to
the XtraDry option or activate AirDry.
How to deactivate AirDry
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
and until the
indicators , , , , and
start to flash and the display is blank.
2. Press .
• The indicators
, , , and
go off.
• The indicator
continues to flash.
• The display shows the current
setting: = AirDry activated.
11