User manual

To lower the basket to the original posi-
tion proceed as follows:
1. Pull out the basket until it stops.
2. Carefully lift both sides upwards and then
allow the mechanism to drop back down
slowly, keeping hold of it.
Never lift or lower the basket on one side
only
With the upper basket raised we recom-
mend you adjust the cup racks in the
lowest position.
After loading your machine always
close the door, as an open door can
be a hazard.
Multi-tab function
This appliance is equipped with the 'Multitab
function', that allows the use of the 'Multitab'
combi detergent tablets.
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ('3 in 1', '4 in 1', '5 in 1' etc.).
Check whether these detergents are suitable
for your water hardness. See the manufac-
turers instructions.
Once this function is selected it will remain
active for all following wash programmes.
With the selection of this function the inflow
of rinse aid and salt from each respective
supply container is automatically deactivated
and also the indicator lights for salt and rinse
aid are deactivated.
When using the 'Multitab function', the cycle
durations may change. If this is the case, the
running time for the programme is
automatically updated on the display.
Activate/deactivate the 'Multitab func-
tion' before the start of a washing pro-
gramme.
Once the programme is running, the
'Multitab function' can NO longer be
changed. If you want to cancel the 'Mul-
titab function' you have to cancel the
programme setting and then deactivate
the 'Multitab function'. In this case you
have to set a washing programme (and
desired options) again.
Activation/deactivation of the Multitab
function
To activate the Multitab function, press the
Multitab button. Corresponding indicator
light comes on.
To deactivate the function press the Multitab
button again. Corresponding indicator light
goes off.
If the drying results are not
satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of func-
tion buttons A , B, and C start flashing.
3. Press function button B, the lights of
function buttons A and C go off while the
light of function button B continues to
flash. The digital display shows the cur-
rent setting.
Rinse aid dispenser deactivated
Rinse aid dispenser activated
12