User manual

x4
The appliance must be level and stable.
A correct adjustment of the
appliance level prevents the
vibration, noise and the
movement of the appliance
when in operation.
When the machine is installed
on a plinth or if a washer dryer
is stacked on the washing
machine, use the accessories
described in chapter
'Accessories'. Read carefully
the instructions supplied with
the appliance and with the
accessory.
The inlet hose
1. Connect the water inlet hose to the
back of the appliance.
2. Position it toward left or right
depending on the position of the water
tap.
20
O
20
O
45
O
45
O
Make sure that the inlet hose is
not in vertical position.
3. If necessary, loose the ring nut to set it
in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4" thread.
CAUTION! Make sure that
there are no leaks from the
couplings.
Do not use an extension hose if
the inlet hose is too short.
Contact the service centre for
the replacement of the inlet
hose.
Water-stop device
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing.
The red sector in the window «A» shows
this fault.
8