User manual

Introduction
The options/functions are not
selectable with all washing
programmes. Check the
compatibility between options/
functions and washing
programmes in the
"Programme Chart". An option/
function can exclude another
one, in this case the appliance
doesn't allow you to set the
incompatible options/functions
together.
Make sure the screen and
touch buttons are always clean
and dry.
Temperature
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on the
display.
When the display shows the indicators
and , the appliance does not heat the
water.
Spin
When you set a programme, the appliance
automatically sets the maximum spin
speed allowed.
Touch repeatedly this button to:
• Decrease the spin speed.
The display shows only the
spin speeds available for the
set programme.
• Activate the Rinse Hold option.
The final spin is not performed. The
water of the last rinse is not drained out
to prevent the fabrics from creasing.
The washing programme ends with
water in the drum.
The display shows the indicator .
The door stays locked and the drum
turns regularly to reduce creasing. You
must drain the water to unlock the door.
If you touch the Start/Pause button, the
appliance performs the spinning phase
and drains the water.
The appliance empties the
water out automatically after
18 hours approximately.
• Activate the Extra Silent option.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator . The
door stays locked. The drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
If you touch the Start/Pause button, the
appliance performs the only draining
phase.
The appliance empties the
water out automatically after
18 hours approximately.
Stain/Prewash
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Stain
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with
stain remover.
Pour the stain remover into
compartment
. The stain remover
will be added in the appropriate phase
of the washing programme.
This option is not available
with a temperature lower
than 40 °C.
• Prewash
14