User manual

Cleaning the inlet hose and the valve filter
1.
1
2
3
2.
3. 4.
45°
20°
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary, clean
the pump.
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. When you drain the water with the
emergency drain procedure, you must
activate again the drain system: Put 2
litres of water in the main wash
compartment of the detergent
dispenser.
2.
Start the programme to drain the water
Frost precautions
If the appliance is installed in an area where
the temperature can be less than 0° C,
remove the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install
the inlet hose again.
WARNING! Make sure that the
temperature is more than 0 °C
before you use the appliance
again. The manufacturer is not
responsible for damages caused
by low temperatures.
21