User manual
Problem
1)
Possible cause Remedy
The loading
door does not
closed
The filter not locked in the position. Put the filter in the correct position.
The laundry is locked between the
door and the seal.
Put the load correctly in the drum.
Err (Error) on
the display.
You try to change the programme
or the option after the start of the
cycle.
Turn the tumble dryer off and on.
Make the new selection.
The option you try to activate is not
applicable with the selected pro-
gramme.
Turn the tumble dryer off and on.
Make the new selection.
No drum light
Defective drum lamp. Contact the service centre to re-
place the drum lamp.
Abnormally
elapsing time
on the display.
The time to end is calculated on the
basis of the volume and dampness
of the laundry.
The automatic procedure — this is
not the appliance malfunction.
Programme in-
active.
The water container is full. Drain the water container, push the
Start/Pause button.
3)
Drying cycle too
short.
Too small laundry volume. Do the selection of time pro-
gramme. The time value must be re-
lated to the load. To dry 1 item or
small quantities of the laundry we
recommend to use short times.
The laundry is too dry. Do the selection of time programme
or higher drying level (e.g. Extra Dry
(Extratrocken))
Drying cycle too
long
6)
The filter is clogged. Clean the filter.
Too high volume of the load. Obey the maximum load volume.
The laundry not spun sufficiently. Spin correctly the laundry.
Too low or too high room tempera-
ture - this is not the appliance mal-
function.
Ensure a room temperature higher
than +5°C and lower then +35°C.
1)
If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the
new programme. Push the Start/Pause button. Does not operate? - contact the service centre and give the error
code.
2)
Follow the programme description — see PROGRAMME TABLE
3)
See chapter CARE AND CLEANING
4)
Only dryers with the Dry Plus (Trocken+) option
5)
See HINTS AND TIPS chapter
6)
Note: After maximum 5 hours the drying cycle ends automatically.
21