User manual

• Make sure that is good airflow in the
appliance installation position.
Adjustment of the remaining
laundry moisture degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the Dry Plus (Trocken+) and Anti-
crease (Knitterschutz) buttons.
One of the symbols goes into the view on
the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6.
To memorise the setting, push at the
same time the Dry Plus (Trocken+)
and Anti-crease (Knitterschutz)
buttons for approximately 2 seconds.
Deactivating the Water
container (Behälter) indicator
The water container indicator is by default
on. It starts to light at the end of the drying
cycle or during the cycle if the water
reservoir is full. If the draining kit is installed
the water container is drained automatically
and indicator can be permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the Dry Plus (Trocken+) and Time
Save (Zeit Sparen) buttons.
One of 2 configurations is possible:
• the Water container (Behälter)
indicator: is on and the symbol
goes into the view - the
water container indicator is
permanently on
• the Water container (Behälter)
indicator: is off and the symbol
goes into the view - the
water container indicator is
permanently off
CARE AND CLEANING
Cleaning the filter
At the end of each cycle the indicator Filter
(Sieb) is on and you must clean the filter.
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
1. Open the door. Pull the filter.
17