Installation Guide

QUICK START GUIDE

40 P PLASMA CUTTER

Connect to input power

Cutting capability

Replace worn consumables

FIND MORE INFORMATION AT FORNEYIND.COM

OPERATING TIPS

Output air pressure is pre-set at the factory

Connect to input air

• 60-120 PSI

•

5.3 CFM

• Clean air

• No oil

• No moisture

Read user manual

TROUBLESHOOTING GUIDE

NOTE: Correct consumable assembly

Torch body

Electrode

Air diffuser ring

Cutting tip: 120V - 0.65

230V - 0.8/0.9

Shield cup (four hole)

ITEM# 440

EN_v2-3

Too fast.Watch

spark trail angle

Touch tip to the

surface of the metal

• Generator OK with continuous

output > 5,000 W

(120V) or 10,000 W (230V)

• Extension cord: #12 AWG

(120V) or #8 AWG

(230V) or larger. 25’ (8m) or

shorter extension cords

recommended

Touch tip to the surface

of the metal

QUESTIONS OR TROUBLE? Contact Forney Industries at 1-800-521-6038 customerservice@forneyind.com

forneyind.com

120V: 1/4” (6,35mm)

230V: 1/2” (12,7mm)

PAGE 1
ITEM# 440 QUICK START GUIDE 40 P PLASMA CUTTER 1. Read user manual + 2. Connect to input air • 60-120 PSI • > 5.3 CFM • Clean air • No oil • No moisture Output air pressure is pre-set at the factory 3. 4. Connect to input power Touch tip to the surface of the metal NOTE: Correct consumable assembly • Generator OK with continuous output > 5,000 W (120V) or 10,000 W (230V) • Extension cord: #12 AWG (120V) or #8 AWG (230V) or larger. 25’ (8m) or shorter extension cords recommended a. Torch body b.