SDS
5. FIRE FIGHTING MEASURES
5.1 Extinguishing agents: Foam, CO2, Dry Chemical
5.2 Special Fire Fighting Procedures and Precautions: Normal fire fighting procedures may be used.
5.3 Unusual Fire and Explosion Hazards: Container may melt and leak in heat of fire. Spills may be slippery.
6. ACCIDENTAL RELEASE MEASURES
6.1 Spill or Leak Procedures: No special requirements. Small amounts of residue may be flushed to sewer with
plenty of water. Larger spills should be allowed to soak into adsorbent material and discarded as solid waste.
Note: Surfaces may become slippery after spillage.
7. HANDLING AND STORAGE
7.1 Handling: Avoid contact with eyes. Do not ingest. Good hygiene practices should be followed when handling
this material. Wash thoroughly after handling.
7.2 Storage: Keep container tightly closed and in a cool, well ventilated area. Keep from excessive heat and freezing.
8. EXPOSURES STANDARDS AND PERSONAL PROTECTION
8.1 Respiratory protection: None required with normal use.
8.2 Hands/Skin protection: None required with normal use.
8.3 Eye protection: Do not get product in eyes.
8.4 Skin protection: No special requirements under normal use.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Creamy-Opaque, Viscous Liquid
Odor: Characteristic
Color: Straw-Light Yellow
Specific Gravity (H20 = 1): approximately 1
Volume of Container: various
Gas flammability: -
pH: 8.5
Solubility in water: Considerable
Percent Volatiles: -
Solubility in oil: -
Flash Point: >200F
Melting Point: Not Applicable – Liquid
Boiling Point: >212F
Refractive Index ~1.40