Instructions / Assembly

1B. Connecting Threaded Stem Casters

Threaded stem casters are more commonly available and come in many stem and wheel

sizes. FORMUFIT Caster Pipe Caps will accept any threaded caster that has a stem diameter

of 1/4", 3/8" or 7/16” and must be at least 1-1/2” in length. To connect a threaded stem caster

to a Caster Pipe Cap, perform the following:

2. Attaching to a PVC Pipe

To attach the assembled caster pipe cap and caster combination to your PVC project,

perform the following steps:

https://formuﬁt.com

Insert the stem of the threaded caster

into the hole on the bottom (smooth

end) of the Caster Pipe Cap.

Connect a washer and corresponding

nut over the threaded stem and

tighten fully with a wrench or socket.

Insert the entire Caster Pipe Cap and

Caster assembly one the end of the

desired PVC Pipe segment.

Tap into place with your palm or a

hammer if necessary.