User's Manual

Configure a Repeater with Wireless Client Association

To activate the Repeater with Wireless Client Association, please do the following:

1. Configure WDS mode for each Access Point:

¾ Configure AP1 on LAN Segment A in Repeater mode with the Remote MAC Address

of AP2.

¾ Configure AP2 on LAN Segment B in Repeater mode with the Remote MAC Address

of AP1 and AP3.

¾ Configure AP3 on LAN Segment C in Repeater mode with the Remote MAC Address

of AP2.

2. After you complete the settings, please click on “Apply” for changes to take effect.

Note: Under Repeater Bridge mode, you can extend this repeater bridge by adding additional

KWA-O5000H Bridges for each additional LAN Segment.

Enable Smart WDS

If this feature is selected, a WDS Service Group ID is required and must be the same with the

ID of other remote Access Points. You can input up to 32 characters. After you complete the

settings, please click on “Apply” for changes to take effect.