User's Manual

24
Configure a Wireless Point-to-Point Bridge
To activate the Point-to-Point Bridge mode please do the following:
1. Configure WDS mode for both Access Point:
¾ Configure both AP1 on LAN Segment A and AP2 on LAN Segment B in Point-to-Point
Bridge mode.
¾ AP1 must have AP2’s Mac address and enter it in the Remote MAC Address field.
¾ AP2 must have AP1’s Mac address and enter it in the Remote MAC Address field.
2. Enable Wireless Client Association:
¾ If enabled, your Access Point is functioning as a regular Access Point, which can
provide the link services to wireless clients. Then, wireless clients can communicate
with other wireless clients that are located in different LAN Segments.
¾ Verify that AP1 and AP2 are both configured in the same LAN network address range
as wireless clients with which associated.
¾ Make sure that Mode, SSID, Channel and encryption settings are set the same for both
of your WDS-compliant Access Points.
3. After you complete the settings, please click on “Apply” for changes to take effect.