User's Manual

13
3-2 IP Setup
WAN/LAN Setup
By default, the Access Point can be configured as a Bridge or a Router.
As a Bridge mode, you can assign a proper IP address to your wireless access point manually
by selecting Static IP. If you would like the wireless access point to obtain the IP address
from the DHCP server on your network automatically, select DHCP Client.
Spanning Tree: You may Enable or Disable the Spanning Tree Protocol used in the Access
Point.
As a Router mode, you can enable AnyIP and manage WAN Port: Ethernet and Wireless.
IP Address: Type the IP address of your Access Point. (Default: 192.168.1.1).
IP Subnet Mask: The Access Point’s Subnet Mask must be the same as your Ethernet
network. We recommended that you do NOT change the value. (Default: 255.255.255.0).
Default Gateway: The access point will use this value for default Gateway.
Primary DNS Server: The access point will use this value for primary Domain Name Server.
Secondary DNS Server: The access point will use this value for secondary Domain Name
Server.