User's Manual

Always:
Make sure battery compartments are secure.
• Use batteries of the correct size and type.
• Fit batteries correctly observing the plus (+) and
minus (-) marks on the battery and compartment.
• Replace a whole set of batteries at each time.
• Remove dead batteries from equipment.
• Remove batteries from appliance that will not be
used again for a long time.
• Please remember that small button cells and AAA
batteries should be kept away from young children
as they could be easily swallowed. Seek medical
advice if you believe a cell has been swallowed.
Never:
• Mix different types of batteries.
• Mix old and new batteries.
• Dispose of batteries in a fire.
• Do not attempt to recharge ordinary batteries.
PLEASE RETAIN THIS INFORMATION
FOR FUTURE REFERENCE.
FUNCTIONS
BATTERY INSTALLATION
BATTERY SAFETY INFORMATION
BATTERY SAFETY INFORMATION
CONNECTING THE WIRELESS TRANSMITTER
The Wireless Speaker System is supplied with a
universal audio cable. This cable can be connected to
the audio source outputs with the 3.5mm plug or the
red/white RCA plugs.
NOTE: THE HEADPHONES SET WILL NOT FUNC-
TION PROPERLY WITH THE 3.5MM AND RED/WHITE
RCA PLUGS AT THE SAME TIME.
1. Connect the single 3.5mm plug to the Line-in jack at
the back of the transmitter (shown in the diagram).
2. Connect the opposite end of the cable (with 3.5mm/ red/
white plugs) to your audio source. You only need to connect
either the 3.5mm plug or the red/white RCA, whichever is
applicable. On most audio devices (including some TV's)
you can connect the 3.5mm plug to the headphones jack.
3. Switch "ON" the transmitter by lifting up the antenna to an
up-right position. The blue LED power indicator will
illuminate. Extend the antenna for maximum range.
4. Turn the speaker ON by rotating the volume dial clockwise.
The blue LED power indicator will illuminate. Adjust the
volume by rotating dial.
General information
• It is technically possible to use multiple speakers with one
transmitter if all:
- Operate in the 49 MHz band
- Work according to the same FM modulation scheme
• Please consult the appliance’s electrical specification
sheets for confirmation on compatibility.
• Please observe the local regulations regarding the disposal
of packing materials, exhausted batteries and old equipment.
• Hearing Safety! Continuous use at high volume may
damage your hearing permanently.
• Remove the batteries from the speaker and transmitter
battery compartments if they will not be used for a long
period of time
• Do not disassemble the product.
SAFETY INSTRUCTIONS
• Long time exposure to loud music may cause hearing
damage.
• Water may damage the internal electronic components.
CAUTIONS! Changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures: -- Reorient or relocate the receiving antenna. 33
-- Increase the separation between the equipment and receiver. --
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. -- Consult the dealer or an
experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Specification*
Transmitter
System: . . . . . . . . . . . . . . . . . . . . VHF/RF
Modulation: . . . . . . . . . . . . . . . . . Frequency Modulation (FM)
Carrier Frequency: ………….. . . . Channel 49.86 MHz
Radiated Output Power: . . . . . . . < 10 mW
Effective Transmission Range: . . .30 feet/10mts**
Input Level: . . . . . . . . . . . . . . . . . .500mV
Power supply: . . . . . . . . . . . . . . . 3 x 1.5V (AAA/UM4) batteries
Battery Life Time: . . . . . . . . . . . . . ~ 10 hours
Speaker
System: . . . . . . . . . . . . . . . . . . . . .VHF/RF
Carrier Frequency: . . . . . . . . . . . . Channel 49.86 MHz
S/N ratio: . . . . . . . . . . . . . . . . . . . .> 50dB (1kHz sine wave,
A-weighted)
Distortion: . . . . . . . . . . . . . . . . . . .≤ 2% THD
Audio frequency range: . . . . . . . . 20-20,000 Hz
Power supply: . . . . . . . . . . . . . . . 4 x 1.5V (C type) batteries
Battery Life Time: . . . . . . . . . . . . .~ 4 hours
* Specification subject to changes ** Depending on ambient conditions
Troubleshooting
If your speaker system is experiencing a noticeable degradation in wireless audio
quality, first check the possible causes below.
If you are unable to remedy the problem by following these hints, check user manual
for further details. Under no circumstances should you try to repair the set yourself.
Problem
Interference from other
radio sources or
fluorescent lamps
Volume level too low
No Sound
Poor Sound Quality
Distortion
Solution
• Move transmitter or receiver elsewhere.
• Adjust the volume level of the speaker, or adjust the output
level of the audio source, which is connected to the
transmitter.
• Ensure the Transmitter switch is in the ON position by
raising the antenna to an up-right position.
• Ensure the speaker volume control is in the ON position.
• Speaker or Transmitter batteries may be too low. Change
batteries.
• Ensure the TV or audio component is ON.
• Adjust the volume control on the speaker to turn up the
volume.
• The connected audio/video equipment is not playing (CD,
Tape, etc…). Check the audio source.
• The volume of audio source is turned down, adjust volume
to an appropriate level.
• Ensure the Antenna on the Transmitter is extended to the
fullest.
• Speaker or Transmitter batteries may be too low. Change
batteries.
• Out of range. Move closer to the Transmitter.
• Speaker batteries may be too low. Change the batteries
and replace with new ones.
• The Speaker is too far from transmitter, move closer.
• The input level of the audio signal is too low. Turn up the
volume of the audio source equipment.
FOR THE SPEAKER
1. Open the battery compartment
cover by loosening the screw
then lift the battery cover up.
Insert four (4) C type 1.5V
Alkaline batteries into the battery
compartment with the (+) and (-)
poles correctly aligned.
2. Before use, secure the
compartment cover by tightening
the screw.
This product is subject to continuous improvement; we reserve the right
to modify product design and/or specifications without notice and
without incurring any obligations.
FOR TRANSMITTER
1. 1. Remove screw to access the
battery compartment. Insert three
(3) AAA 1.5V Alkaline batteries with
the (+) and (-) poles correctly
aligned.
2. Before use, secure the
compartment cover by tightening
the screw.
CHANGING THE BATTERIES
If the power indicator light is dim
you may need to replace the
battery. Please follow instructions
above for replacing (installing)
batteries.
Thank you, we hope you enjoy your selection. The
Wireless Speaker System incorporates reliable radio
frequency (RF) technology allowing you to place the
speaker around the house or on the patio, up to 30 ft
from the audio source – and without wires. The
transmitter simply connects to any audio source such
as an iPod, MP3 player, game system, CD player, TV
or Stereo receiver.
FEATURES
• 49mhz Radio Frequency (RF) technology.
• Operating distance up to 30 ft (10m).
• No line-of-sight limitations works through walls.
• Power switch built into telescoping antenna.
• Line-in jack for optional direct-to-source connection.
Connect your MP3 player directly to the speaker with
the provided cable – you can bring your music
anywhere.
This Category II radiocommunication device complies with
Industry Canada Standard RSS-310.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device.
Power ON/OFF
Light
Indicator
Line IN Jack
Speaker
Wireless Speaker
System
Instruction Manual
Model: R08
GB
+ Volume
Audio Player
(source with
3.5mm output/
standard
headphones
jack)
TV/Receiver
(source with
RCA outputs)
Front
A3 Folded size:105 x 84mm
fold fold fold
fold fold
fold
fold
fold
Back
fold foldfold
fold