Technical Specifications

02621-2
1.5 SUBMITTALS
A. Submit under provisions of Section 01300.
B. [ Product Data ]: Manufacturer's data sheets on each product to be used, including:
1. Preparation instructions and recommendations.
2. Storage and handling requirements and recommendations.
3. Installation methods.
C. Shop Drawings: Indicate layout of system; include all components specified in
manufacturer's descriptive literature or installation instructions, and components
indicated on the Drawings.
D. Manufacturer's Certificates: Certify products meet or exceed specified requirements.
1.6 DELIVERY, STORAGE, AND HANDLING
A. Store products horizontally with slotted sides down, on pallets off the ground in
manufacturer's unopened packaging until ready for installation.
B. Do not store in direct sunlight or in high heat environment exceeding 150 degrees F
(66 degrees C).
C. Store and dispose of solvent-based materials, and materials used with solvent-
based materials, in accordance with requirements of local authorities having
jurisdiction.
PART 2 PRODUCTS
2.1 MANUFACTURERS
A. Acceptable Manufacturer: CertainTeed Corp., Foundation and Pipe Products, which
is located at: 750 E. Swedesford Rd. P. O. Box 860 ; Valley Forge, PA 19482; Toll
Free Tel: [phone]; Fax: [phone]; Email: request info; Web:
www.certainteed.com/CertainTeed/Undefined/Foundations
B. Substitutions: Not permitted.
C. Requests for substitutions will be considered in accordance with provisions of
Section 01600.
D. Unless otherwise specified for an individual product or material, supply all products
specified in this section from the same manufacturer.
2.2 COMPONENTS
A. Linear Components: Polyvinyl chloride (PVC) containing post-consumer recycled
plastic materials, extruded in closed-channel cross-section, with slot perforations
along length to permit moisture migration, 12 foot (3.65 m) lengths.
1. Load Deflection and Impact Resistance: Comply with requirements of ASTM
F 891 for Type PS 25 PVC pipe.
2. Flow Characteristics: Meet or exceed the flow characteristics of 4 inch (100
mm) diameter corrugated polyethylene slotted pipe conforming to ASTM F
405, when subjected to 30-7/8 inch (770 mm) pressure head.
3. Type: Form-A-Drain Part LN124, size 2-1/4 inches (57 mm) wide by 4 inches
(101 mm) deep, single-channel.
4. Type: Form-A-Drain Part LN126, size 2-1/4 inches (57 mm) wide by 6 inches
(152 mm) deep, dual-channel.