Installation Instructions

ROUGH LAYOUT
Begin with the rough layout of the required number of
standard 12' lineals, couplings, 90˚ corners, 45˚ corners,
drain outlets and other necessary accessory parts.
CUTTING
Cut lineals to the required length using a hand or power
saw. Do not pre-plan or pre-cut lengths. Simply cut to
length when required and use remaining piece as the next
piece to be installed. This approach will help minimize
waste by ensuring that numerous short pieces are not
left over. At a corner, cut lineal to required length, insert
into corner and start around the corner with the piece
just cut off. Square cuts help ensure proper alignment
into couplings, corners and other accessories.
CIRCULAR SAW
RECIPROCATING SAW
HAND SAW
ASSEMBLY
Insert lineals into couplings, corners, or outlets to
construct each side of the footing form. Slotted side of
the lineal faces away from the concrete. Accessory items
are manufactured to ensure a snug fit, so lubricant or
solvent cement is not necessary. Spacer straps may be
used to ensure proper footing width. Pin the corners
in place during set-up by driving a rebar stake into the
ground through the holes in the corners. This will keep
the system aligned and make set-up easier.
STEP-BY-STEP INSTRUCTIONS
2