Instructions / Assembly

CORNER PANELS
If installing on a corner, holes must be drilled on the appropriate side to make a 90° angle. When drilling, make
sure they are aligned with the pre-drilled dimples. Once holes are drilled, install panels in the same manner as
menoned above.
GATE INSTALLATION
Determine which side you would like the gate hinge to be mounted, and mark holes on the post to idenfy
hinge locaon. Measuring from the boom of the post cap to the boom of the hinge, the top hinge should
measure 8.75” from the boom of the post cap, while the boom hinge should measure 40.25” from the
boom of the post cap. Drill 3/8” holes in post where the hinges will be installed.
8.75” - Top Post Hinge (40.45” for the bottom post hinge)
Next, mount gate side of hinge into exisng holes in the gate. Mount the boom post hinge on the post with
nuts and bolts included. Do the same for the top hinge. Install gate by hooking the boom gate side hinge into
the boom post hinge, and the same for the top. Once connected, bolt into place.