Installation Instructions

40.5mm
(1-
3
/5”)
90.5mm
(3-
9
/16”)
100mm
(3-
15
/16”)
Remove the Anti-Jump Screw and Toothed Washer from each Door Hanger.
Mark the location of the through holes for the Door Hangers on the side of the door facing
away from the Track as shown in the diagram. Drill the holes using a 10mm (
7
/16”) bit.
Insert the Bolts through the door on the side facing the Track, and secure the Door Hanger by
adding two Washers and an Hex Nut to each Bolt. Hand tighten both Nuts before securing
with a wrench.
IMPORTANT
The widest part of the Spacer should be placed on
the wall.
The Joint Plate should be on the side of the Track
facing away from wall, and on the BOTTOM of the
Track.
Place one Lag Screw through the hole on one end hole
of the Track, through a Spacer, and drive the Lag
Screw into the pilot hole. DO NOT fully tighten Lag Screw.
Repeat process for Lag Screw on opposite end of Track. DO NOT fully tighten Lag Screw.
For remaining holes in Track, insert Lag Screw through hole and through Spacer, and drive into
pilot hole. DO NOT fully tighten Lag Screws.
After all Lag Screws and Spacers are in place, use a level on top of the Track to make sure it is
properly level. While the level is on top of the Track, tighten all Lag Screws.
3 - Install Hangers and Hang the Door