Use and Care Manual

Remove all protective material carefully. Avoid cutting the surface of the furniture while removing the
packaging material. Carefully turn the table top (A) upside down on a soft surface. Align the holes in the
table legs (B) with the holes in the table top (A). Loosely secure table legs (B) to table top (A) by the bolts (C)
through lock washers (E), flat washers (D), using wrench (F).
As shown in figure 1.
DO NOT TIGHTEN BOLTS AT THIS POINTS.
1
Check the alignment of all table legs (B), and adjust if necessary. Once the alignment is correct and all bolts (C) are
in place, tighten all bolts (C) using wrench (F).
With the help of another person, carefully turn the table to the upright position. Put the umbrella cover (G) on it.
The table is ready for your enjoyment.
2
B
Figure 1
G
A
Figure 2
A
C
E
D