Use and Care Manual

Remove all protective material carefully. Avoid cutting the surface of the furniture while removing the packaging

material.

Place the chair seat (A) on a non-abrasive flat surface. Align the holes on the support bar on the underside of the

chair seat with the holes on the spring plates attached to the t-rocker that is pre-attached to the chair base (B).

Make sure the arrow labels on the rocker mechanism and chair support bar are facing the same direction—towards

the front of the chair.

The support bar and spring plate should be sandwiched in between the C-Clamp Alum plates (D). Insert bolts (C)

through the C-Clamp Alum plates (D), support bar and spring plate. as showed in the diagram. Secure bolts with flat

washers (E), lock washers (F) and nuts (G). Warning: Improper assembly may result in serious personal

injury.

Once all the nuts and bolts are in place, securely tighten all the bolts (C) and nuts (G), including the ones at the front

part on the rocker mechanism with the wrench (H). Place the cushion (I) on the rocking club chair .

Test the swivel rocker gently. If the rocker does not rock properly, double check the assembly procedure.

REPEAT THE ABOVE STEPS TO ASSEMBLE THE OTHER CHAIR.

support bar

STEP 1

STEP 2

Spring plate