Instruction Manual

VALD ForceDecks Instruction Manual v.1.2022
6
4.2 ForceDecks Setup
ForceDecks plates can be mounted on:
• Steel bases;
• Set into weightlifting platforms; or
• Used freestanding on any flat, hard surface.
4.3 Floor Considerations
ForceDecks are designed to be mobile, however it is important ForceDecks are mounted on a
surface that is:
• As rigid as possible; and
• As flat as possible.
For example, concrete floors are ideal, whereas sprung floors are not suitable.
Rebounding vibrations or ringing may occur if the platform is placed on the wooden section of some
Olympic lifting platforms.
Note: If clients are unsure about the rigidity of their floor, they can check for vibrations by examining a
force-time trace or by sending a recording to [e-mail] for assessment.
We also recommend using a spirit level to identify an even part of the floor and marking out the
space if clients are planning to move the plates.
4.4 Space Considerations
If the force plates are to be embedded into the ground or into a raised lifting platform, it is important
to leave adequate space around the plates to prevent contact with the surrounding walls and to
allow access to cables.
4.4.1 Preventing Crosstalk
Crosstalk is the unwanted transfer of force between plates. This can occur when two plates are in
contact, potentially resulting in inaccurate readings.
It is important to leave a small gap between the left and right plate to minimise interference and a
small gap between the outside edge of the safety frame or casing if applicable.
4.5 Cable configuration
Both V.2 ForceDecks plates are identical, and the orientation of the Interplate Cable determines the
default left plate (Primary) and right plate (Secondary) in the ForceDecks software.