Pseries Installation Guide

P-Series Installation and Operation Guide, version 2.3.1.2 81
Related
Commands
pnic aggregate-mode-enable
Receive both client-to-server and server-to-client traffic on one port. This is the default
behavior.
Syntax
pnic aggregate-mode-enable [number]
Disable aggregate mode using the command
pnic aggregate-mode-disable.
Parameters
Command
History
Example
Figure 41 pnic aggregate-mode-enable Command Example
[root@localhost SW]# pnic aggregate-mode-enable
No card number specified. Assuming card 0
*** Aggregate mode enabling on card:0 successful.
[root@localhost SW]#
Related
Commands
pnic apply-firmware
Apply a specific firmware image to the card. You must specify either the firmware name or
the complete path of the firmware.
Syntax
pnic apply-firmware [number]
pnic aggregate-mode-enable Receive both client-to-server and server-to-client traffic on
one port.
number
(OPTIONAL) Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.3.0.0 Introduced
pnic aggregate-mode-disable Receive client-to-server and server-to-client traffic on
different ports. This is the default behavior.