Pseries Installation Guide

80 Appendix A

• pnic showconf on page 108

• pnic show-firmwares on page 108

• pnic showtech on page 109

• pnic start on page 110

• pnic stop on page 111

• pnic temp-mem-disable on page 112

• pnic temp-mem-enable on page 112

• pnic updatemacvalue on page 113

• pnic vlan-remove-disable on page 114

• pnic vlan-remove-enable on page 114

• pnic web-gui-start on page 115

• pnic web-gui-stop on page 116

Note: The P10 does not support multiple network interface cards. Therefore, the only

valid entry for the number variable is 0.

Card 0 and Channel 0 are assumed for all commands if the card and

mber options

are not specified.

pnic aggregate-mode-disable

Receive client-to-server and server-to-client traffic on different ports.

Syntax

pnic aggregate-mode-disable [number]

Enable aggregate mode using the command

pnic aggregate-mode-enable.

Parameters

Command

History

Examp

Figure 40 pnic aggregate-mode-disable Command Example

[root@localhost SW]# pnic aggregate-mode-disable

No card number specified. Assuming card 0

*** Aggregate mode disabling on card:0 successful.

[root@localhost SW]#

number

(OPTIONAL) Enter the number of the network interface card.

Range: 0-5

Default: 0

Version 2.3.0.0 Introduced