Pseries Installation Guide

P-Series Installation and Operation Guide, version 2.3.1.2 27
Managing Rules, Policies, and Firmware
Enter the m command from the GUI command line (see “GUI Commands” on page 26) to invoke a menu
that enables you to manage dynamic rules, capture/forward policies, and firmware. Three options are
available; they are shown in Figure 14 and described in Table 4.
Figure 14 Rule Management GUI
fn9000011
PNIC0 Not Active
u Brings the OS network interface up and enables matching. This is similar to the command s, but it
does not load/reload the driver. It is only valid after the command s has been executed.
x Toggles the direct memory access (DMA) off and on to enable or disable capturing to the host,
respectively.
z Disables the DMA and brings the interface down, in succession. This is equivalent to issuing the
commands pnic down and pnic off, in succession.
Note: Commands 1, 2, 3, 4, and 5 are for engineering use only. If you enter a command 1 through 5 by
mistake, enter 0 to return to the runtime statistics screen.
Table 3 GUI Commands
Command Description