Pseries Installation Guide

112 Appendix A
pnic temp-mem-disable
Disable temporary memory.
Syntax
pnic temp-mem-disable [number]
Enable temporary memory using the command pnic temp-mem-enable.
Parameters
Command
History
Example
Figure 79
[root@localhost SW]# pnic temp-mem-disable
No card number specified. Assuming card 0
*** Disabling temporary memory on card:0 successful.
[root@localhost SW]#
pnic temp-mem-disable Command Example
Related
Commands
Usage
Information
Disabling the temporary memory reduces flow collisions. In firewall mode (default-drop),
temporary memory is disabled automatically.
pnic temp-mem-enable
Enable temporary memory. This is the default behavior.
Syntax
pnic temp-mem-enable [number]
Disable temporary memory using the command pnic temp-mem-disable.
Parameters
Command
History
number
Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.3.0.0 Introduced
pnic temp-mem-enable Enable temporary memory.
number
Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.3.0.0 Introduced