Service Manual

set pt filter - 1 arg: 1 220nf cap in pipetracker filter, 0 for 10nf
set filter - 1 arg: 1 for cutoff at 50hz, 0 for cutoff at 500hz
set gain - 1 arg: 1 for high gain (100), 0 for low gain (10)
mute vectors - 1 arg: 1 mutes vectors, 0 unmutes them
mute status - 1 arg: 1 mutes status messages, 0 unmutes them
electrode distance - 1 arg: X (float), set the electrode distance to X
raw dump - 1 arg: Dump the last X raw data
hall dump - Dump the last 900 hall samples
menu - 1 arg: 1 enables the menu, 0 disables it
motor run - 1 arg: "start" starts the motor, "stop" stops it
rotor power - 1 arg: 1 turns on the rotor, 0 turns it off
set control - 2 args, arg 1: k/p/i, arg 2: value
set baud - 1 arg,: "low": 19200 "medium": 115200 "high": 1000000
save - 1 arg, X: Save current settings to slot X (0-4)
load - 1 arg, X: load settings from slot X (0-4)
erase - 1 arg, X: erase settings at slot X (0-4)
rotor relative cal - 2 args, arg1: Deg, arg2: Amplitude, stores calibration with current settings
use rotor relative cal - 1 arg: 1 to use rotor relative calibration (if available), 0 to ignore rotor
relative calibration
rotor absolute cal - 2 args, arg 1: measured voltage (micro volts), arg 2: rms/amp/pp
use rotor absolute cal - 1 arg: 1 to use rotor absolute calibration (if available), 0 to ignore rotor
absolute calibration
use geometry factor - 1 arg: 1 to enable geometry factor correction, 0 to disable it
set geometry factor - 1 arg: geometry factor
set figs type - 1 arg: fat/slim
How to send commands
Commands can be sent by typing the commands in the terminal window. The other option is to use a
computer program to send the command. To send a command, one must send one and one character, not a