Service Manual

24 volt: 23.68 24 volt value
target rpm: 0 target motor speed
actual rpm: 0.00 actual motor speed
average rpm: 0.00 average motor speed
std rpm: 0.00 standard deviation motor speed
min rpm: 0.00 minimum motor speed
max rpm: 0.00 maximum motor speed
throttle: 0 throttle
comm angle: 0.000000 commutation angle
use stored CA: 0 use stored commutation angle, 1 is enabled, 0 is disabled
version: 0.9.0 motor software version
motor phase current: 0.03 motor phase current
{VECTOR}
{VECTOR} contains the following parameters, separated by tab (\t)
x: 0.470132 Measurement value x-component
y: -0.755581 Measurement value Y-component
E: -6.961971 Electrode polarization
xa: -0.020 Inclinometer x-value
ya: -0.963 Inclinometer y-value
za:-0.086 Inclinometer z-value
len: 922 Received bytes from rotor
{RAWDMP}
{RAWDMP} contains raw measurements from the rotor. {RAWDMP} is followed by 10 values separated by
newline (\n)
-336.621908
-336.621651
-336.621422
-336.621190
-336.620852