Service Manual

auto gain lower: 6 auto gain lower limit
auto gain upper: 85 auto gain upper limit
auto gain enabled: 1 auto gain, 0 is deactivated, 1 is active
master version: 0.9.2 Master software version
{R STAT}
{R STAT} contains the following parameters, separated by tab (\t) or newline (\n)
id: 4653098 A unique number identifying the rotor processor
hum: 31.12 Relative humidity
temp: 28.16 Rotor temperature in °C
5.5 volt: 5.4 5.5 volt value
supply volt: 24.32 supply voltage
rotor state: 1 rotor state, 1 is measure, 2 is impedance
50hz filter: 1 50Hz filter. 1 is enabled, 0 is 500Hz enabled
220nf cap: 0 Pipetracker filter. 1 is enabled, 0 is disabled
100x gain: 1 Gain settings. 0 is 10x, 1 is 100x
version: 0.9.0 Rotor software version
{M STAT}
{M STAT} contains the following parameters, separated by tab (\t) or newline (\n)
id: 2883615 A unique number identifying the motor processor
hum: 43.56 Relative humidity
temp: 28.54 Motor temperature in °C
accel x: 1.03 Inclinometer x-value
accel y: 0.01 Inclinometer y-value
accel z: -0.01 Inclinometer z-value
motor current: 11 motor current
coil current: 0.17 coil current
coil voltage: 27.94 coil voltage
5 volt: 4.33 5.5 volt value