User Manual

EN
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns Arms
Elevator
Ailerons
Rudder
Nose Gear
More control throw Less control throw
PNP Receiver Selection and Installation
The Spektrum AR636A receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 4-channel full range
(sport) receiver. Refer to your receiver manual for correct installation and
operation instructions.
Installation (AR636 shown)
1. Remove the battery hatch from the fuselage.
2. Mount the receiver parallel to the length of the fuselage as shown. Use
double-sided servo tape.
CAUTION: Incorrect installation of the receiver could cause a crash.
3. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration.
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
9