User Manual

EN
The Spektrum AR636 receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 6-channel full range
(sport) receiver. Refer to your receiver manual for correct installation and
operation instructions.
Installation (AR636 shown)
1. Remove the wing from the fuselage.
2. Mount the receiver parallel to the length of the fuselage as shown. Use
double-sided servo tape.
CAUTION: Incorrect installation of the receiver could cause a crash.
3. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration
TIP: An AS3X setup fi le for the AR636 compatible with this airplane may be
downloaded at Spektrumrc.com.
1. Click on the tab labeled Setups/Updates and Air Receiver Setups in the
drop down menu.
2. Select AR636.
3. Under the Receiver Confi gurations button select the download for
EFL6750 P-51D Mustang
4. Install the fi le on the AR636 with the SPMA3065 programming cable.
Receiver Selection and Installation
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
5 = Gear
6 = Flaps
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the fl ight battery.
4 Fully assemble the airplane.
5 Setup Transmitter using transmitter setup chart.
6 Install the fl ight battery in the aircraft (once it has been fully charged).
7 Check the Center of Gravity (CG).
8 Bind the aircraft to your transmitter.
9 Make sure linkages move freely.
10 Test the retract operation.
11 Test the fl ap operation.
12 Perform the Control Direction Test with the transmitter.
13 Perform the AS3X Control Direction Test with the aircraft, if applicable.
14 Adjust fl ight controls and transmitter.
15 Perform a radio system Range Test.
16 Find a safe open area to fl y.
17 Plan fl ight for fl ying fi eld conditions.
Prefl ight
4